FOHHN D-2.1500• 2CH DSP Endstufe
Weitere Infos
2 Kanal Digital-Endstufe, 2x 900 W / 4 Ohm, 2x 1500 W / 8 Ohm integrierter Fohhn Audio DSP, fernbedienbar über Laptop mittels Fohhn-Net Remote
Verstärker für unsere Lautsprecher Systeme. Hier finden Sie hier eine Auswahl an DSP Endstufen zu mieten.
Weitere Infos
2 Kanal Digital-Endstufe, 2x 900 W / 4 Ohm, 2x 1500 W / 8 Ohm integrierter Fohhn Audio DSP, fernbedienbar über Laptop mittels Fohhn-Net Remote
Weitere Infos
2 Kanal Digital-Endstufe, 2x 750 W / 4 Ohm, 2x 390 W / 8 Ohm integrierter Fohhn Audio DSP, fernbedienbar über Laptop mittels Fohhn-Net Remote
Weitere Infos
It can remotely monitor the status of power amplifier, set compression Controller, limiter, noise gate, parametric equalization, matrix routing, delay and other DSP functions in real time. Simple software interface provides customers with simple setup and operation experience.
Technische Daten
Preset:
Vegas 24, Vegas 6.5, Vegas 8CX, Vegas 10.
Weitere Infos
Features
Power Factor Correction PFC for low power consumption and compatibility with a wide range of voltages
Smart Rails Management increases efficiency by means of dynamic rails modulation
Top-grade DSP with high dynamic range and extensive feature set
Complete user interface integrated with ArmoníaPlus
4.3″ IPS touch display and rotary encoder with pushbutton
4 input channels with physical analog and digital AES3 connectors provide maximum flexibility
Improved reliability thanks to the customizable input backup policy that allows to automatically switch input source in case of signal failure
Input and output IIR, FIR, IIR+FIR equalizers and raised-cosine filters
Complete sets of limiters: peak, RMS voltage, RMS current, and TruePower™
Compensation of the speaker cable losses with Active DampingControl™
Full protection circuitry: over/under AC voltage; troublesome signals (clipping, VHF, long-term RMS); DC; thermal; short circuit; mute at power on/off
Technische Daten
Number of channels 4
Output power
(per channel) Single channel mode: 2000 W @ 2 Ω, 2000 W @ 4 Ω, 1400 W @ 8 Ω
Bridge mode: 4000 W @ 4 Ω, 4000 W @ 8 Ω
Max output voltage 155 V peak
Max output current > 55 A peak
Power consumption @ 100 V – Standby: 16 W | 1/8 Power @ 4 Ω: 1460 W
@ 240 V – Standby: 17 W | 1/8 Power @ 4 Ω: 1440 W
Current Draw (1/8 Power @ 4 Ω) @ 100 V – 15.3 A
@ 240 V – 6.6 A
Weitere Infos
Output: 4 – 2x Speakon NL4, bridgeable per channel pair
Input Ananlog: 4x XLR (female)
Input Digital AES3: 1x XLR (female), 1x XLR (male) LINK
Max input level: 24 dBu
Frequency Response: 20 Hz – 20 kHz +/-0.5 dB
Crosstalk: (1 kHz) <-70 dB
Input impedance: 20kOhm Balanced
CMRR: >65 dB
THD+N (from 0.1 W to Half Power): < 0.1% (typical < 0.05%)
SMPTE IMD (from 0.1 W to Half Power): < 0.1% (typical < 0.05%)
Output impedance at 100 Hz: 26 mOhm
AD/DA converters: 24 Bit TandemTM @ 48 kHz
Sample rate converter: 24 Bit @ 44.1 kHz to 192 kHz
Internal precision: 32 bit ?oating point
Latency: 2.5 ms fxed latency architecture
Memory/Presets: 256 MB (RAM) plus 512 MB ?ash for presets
Delay: 2 s (input) + 100 ms (output) for time alignment
Equalizer: custom FIR, peaking, hi/lo-shelving, all-pass, band-pass, band-stop, hi/lo-pass
Crossover: linear phase FIR, Butterworth, Linkwitz-Riley, Bessel
Limiters: TruePowerTM, RMS voltage, RMS current, Peak limiter
Damping control: Active DampingControlTM and LiveImpedanceTM measurement
Weitere Infos
Output: 4 – 2x Speakon NL4, bridgeable per channel pair
Input Ananlog: 4x XLR (female)
Input Digital AES3: 1x XLR (female), 1x XLR (male) LINK
Max input level: 24 dBu
Frequency Response: 20 Hz – 20 kHz +/-0.5 dB
Crosstalk: (1 kHz) <-70 dB
Input impedance: 20kOhm Balanced
CMRR: >65 dB
THD+N (from 0.1 W to Half Power): < 0.1% (typical < 0.05%)
SMPTE IMD (from 0.1 W to Half Power): < 0.1% (typical < 0.05%)
Output impedance at 100 Hz: 26 mOhm
AD/DA converters: 24 Bit TandemTM @ 48 kHz
Sample rate converter: 24 Bit @ 44.1 kHz to 192 kHz
Internal precision: 32 bit ?oating point
Latency: 2.5 ms fxed latency architecture
Memory/Presets: 256 MB (RAM) plus 512 MB ?ash for presets
Delay: 2 s (input) + 100 ms (output) for time alignment
Equalizer: custom FIR, peaking, hi/lo-shelving, all-pass, band-pass, band-stop, hi/lo-pass
Crossover: linear phase FIR, Butterworth, Linkwitz-Riley, Bessel
Limiters: TruePowerTM, RMS voltage, RMS current, Peak limiter
Damping control: Active DampingControlTM and LiveImpedanceTM measurement
Weitere Infos
Output: 4 – 2x Speakon NL4, bridgeable per channel pair
Input Ananlog: 4x XLR (female)
Input Digital AES3: 1x XLR (female), 1x XLR (male) LINK
Max input level: 24 dBu
Frequency Response: 20 Hz – 20 kHz +/-0.5 dB
Crosstalk: (1 kHz) <-70 dB
Input impedance: 20kOhm Balanced
CMRR: >65 dB
THD+N (from 0.1 W to Half Power): < 0.1% (typical < 0.05%)
SMPTE IMD (from 0.1 W to Half Power): < 0.1% (typical < 0.05%)
Output impedance at 100 Hz: 26 mOhm
AD/DA converters: 24 Bit TandemTM @ 48 kHz
Sample rate converter: 24 Bit @ 44.1 kHz to 192 kHz
Internal precision: 32 bit ?oating point
Latency: 2.5 ms fxed latency architecture
Memory/Presets: 256 MB (RAM) plus 512 MB ?ash for presets
Delay: 2 s (input) + 100 ms (output) for time alignment
Equalizer: custom FIR, peaking, hi/lo-shelving, all-pass, band-pass, band-stop, hi/lo-pass
Crossover: linear phase FIR, Butterworth, Linkwitz-Riley, Bessel
Limiters: TruePowerTM, RMS voltage, RMS current, Peak limiter
Damping control: Active DampingControlTM and LiveImpedanceTM measurement
Weitere Infos
Output: 4 – 2x Speakon NL4, bridgeable per channel pair
Input Ananlog: 4x XLR (female)
Input Digital AES3: 1x XLR (female), 1x XLR (male) LINK
Max input level: 24 dBu
Frequency Response: 20 Hz – 20 kHz +/-0.5 dB
Crosstalk: (1 kHz) <-70 dB
Input impedance: 20kOhm Balanced
CMRR: >65 dB
THD+N (from 0.1 W to Half Power): < 0.1% (typical < 0.05%)
SMPTE IMD (from 0.1 W to Half Power): < 0.1% (typical < 0.05%)
Output impedance at 100 Hz: 26 mOhm
AD/DA converters: 24 Bit TandemTM @ 48 kHz
Sample rate converter: 24 Bit @ 44.1 kHz to 192 kHz
Internal precision: 32 bit ?oating point
Latency: 2.5 ms fxed latency architecture
Memory/Presets: 256 MB (RAM) plus 512 MB ?ash for presets
Delay: 2 s (input) + 100 ms (output) for time alignment
Equalizer: custom FIR, peaking, hi/lo-shelving, all-pass, band-pass, band-stop, hi/lo-pass
Crossover: linear phase FIR, Butterworth, Linkwitz-Riley, Bessel
Limiters: TruePowerTM, RMS voltage, RMS current, Peak limiter
Damping control: Active DampingControlTM and LiveImpedanceTM measurement
Technische Daten
Technische Details
Aufbau – Class-D Verstärkertechnologie mit Zero-Latenz
– Schaltnetzteil mit Powerfaktorkorrektur und 3-Phasen Lastausgleich
Betriebsarten – Vierkanal
– Zweikanal gebrückt
Ausgangsleistungen
8× 1600W @ 8 Ohm
8× 3000W @ 4 Ohm
8× 5200W @ 2 Ohm
Betriebsspannung 100-240V, 50/60Hz
Presetspeicher 1000+
DSP – raised cosine equalization
– 2000+ 100ms delay
– FIR und parametrische Filter (IIR, Hochpass, Tiefpass, Allpass)
– frei einstellbarer Peak- und Powerlimiter pro Kanal
– TruePower™
– Active Damping Control™
VIBS show-tech
gegenüber der Fontanastrasse 12
grünes, grosses Tor
7000 Chur
Mieten und Kaufen für Video- und Ton in der Schweiz